| 
  • If you are citizen of an European Union member nation, you may not use this service unless you are at least 16 years old.

  • Work with all your cloud files (Drive, Dropbox, and Slack and Gmail attachments) and documents (Google Docs, Sheets, and Notion) in one place. Try Dokkio (from the makers of PBworks) for free. Now available on the web, Mac, Windows, and as a Chrome extension!

View
 

Up! 3D Printer Examples

This version was saved 10 years, 3 months ago View current version     Page history
Saved by Franc Carter
on September 4, 2011 at 6:43:32 pm
 

On Saturday Madox bought his Up! 3D Printer to the same space so that we could see the print quality that could got out of this 'off the shelf' printer.

 

The setup was a 5-10 minute, find a bench, find power, attach power and then we were ready for a calibration print. From recollection the calibration print took about 30 minutes. As a side note it was later discovered that there was a slight error made in the calibration and hence the prints were not as good as they could have been - which is interesting because the printer still produced high quality prints.

 

Servo Bracket

This is a print of an servo mounting bracket that I am working on, both as a practical mount and as a learning exercise for modeling parts that to actually use. The model is parametric and the values used for this print are fairly aggressive (and probably not practical for actual use). However the Up! did a good job - i am especially impressed by how well it managed the hooks circled in red.

 

Vertical Blind Hanger

The hangers inside the blinds in my unit are pretty poor quality and hence fail every so often - very annoying! Madox modeled it in 5-10 minutes and then we printed two - one horizontally and one vertically. In the image below, the three parts from top to bottom are - the original, pretty vertically and printer horizontally. The two printed ones have gone in to use as replacement parts.

 

Organic Lamp Post

 

We then started looking for more challenging parts to printer http://www.thingiverse.com/thing:7885

 

Elvis

 

 

Comments (0)

You don't have permission to comment on this page.